2007.5-2013 GM Truck

This kit has been developed to seamlessly retrofit the 10spd trans into the 2007.5-2013 GM 1500 Trucks.

The following models are supported with this kit:

07.5-13 Silverado / Sierra 1500 equipped with 4 speed or 6 speed transmissions. 2 or 4wd

Kit includes a plug and play harness, pre-programmed and unlocked transmission control module, and our PSS Conversion Module. No further re-programming is necessary for installation, but may be needed for optimal performance. 

Retains ALL OEM vehicle features including, but not limited to:

Remote Start
CruiseControl
Immobilizer
Antilock Brakes
Traction Control
Backup Camera
Torque Management
Manual Mode
Tow/Haul Mode
Manual Mode Gear Position Indicator 1-6 or 1-8 (Maximum for OEM Equipped Display)

Our harnesses are proudly handmade in the USA with the highest quality components to ensure years of worry-free service.

**4 speed Truck will require cluster, shift lever, and BCM program to allow for Manual mode operation. Those items, and send in programming service are NOT included in the kit, and will be offered with our store, and also preorders *with additional purchase required.

**INSTALL NOTES**

- Most of this info will be covered on Q&A at a later time. 

2WD - Depending on ride height, and current vehicle configuration, Driveshaft modifications may be required.
10L80 uses the same slip yoke as a 6L80 but vented - Its recommended to have about 1 inch of gap between slip, and trans with vehicle on the ground. Custom Driveshafts available upon request 

4WD - OEM 6 Speed transfercase will need to be modified in order to be reused. The input shaft will need to be cut shorter, or changed.  Driveshafts will be reused. 4L60 transfercase is not compatible. 

Some additional small parts required. These variations will be covered in our Q&A section, but at this time - Supplemental parts list for the small parts required to complete install will be provided with the install kits, and instructions.

More info to come as time allows